11/09/2017
I decided to weld the arm pieces onto the torso. I started with the left arm and the palm of the hand. I am totally winging this. Since the piece is in motion I want the arm position to reflect movement. The left shoulder dips and the elbow digs into his side. The left forearm has to be free so the fingers can to move up and down the violin. The violin will be held in place between his chin and his shoulder/chest.
Next I decide to trace my hand to determine how long the finger pieces of steel should be. Then I draw in the bones and measure how long each finger bone is between the joints. My hand is smaller than the figures would be but by the time I add the lath and cement it should be the right size.
My hand pattern with bone measurements.
The hand pattern with two pieces of the palm of the hand bones cut.
Detail of the left arm and the palm of his hand.
The bones in the palm of the hand.
Now I need to see if I am anywhere close on the angle of the forearm and back of hand. I will do this by holding up a violin to the figure.
No, I missed it. Tomorrow I will cut the forearm off and reattach it with the wrist right under the violin. Then I will look at the angle of the hand. That might also need to be altered. Totally winging it.
